Corners

Inside Corner

• Generally installed vertically.
• Used to trim the joint where two walls join to form an inside corner.
• The sloped (step-down) edges of the profile are designed to fit over the rib of a standard AG panel.

Outside Corner

• Generally installed vertically.
• Used to trim the joint where two walls join to form an outside corner.
• The sloped (step-down) edges of the profile are designed to fit over the rib of a standard AG panel.

Base/Ledge Trim

Base and/or Ledge trim is designed to be the at the bottom of a vertical wall panel.

Base Trim/”Rat Gaurd”

• Acts a ledge for the panels to rest on as well as dropping down to cover any potential gap between the wall and foundation
• Gaurds against easy access by rodents or other small animals.

Base Ledge

• Acts a ledge for the panels to rest on

“Z” Ledge

• Acts a ledge for the panels to rest on with a drop down to cover lower material.
• “Z” shaped
• Ideal as trim separating panels installed end-to-end on a wall for two-toned wall.

“J” Channel”

“J” shaped

Used to trim cut panel edges around windows, doors, the tops of walls, etc…